Analysis on dynamic tensile extrusion behavior of UFG OFHC Cu
SCIE
SCOPUS
- Title
- Analysis on dynamic tensile extrusion behavior of UFG OFHC Cu
- Authors
- Park K.-T.; Park L.; Kim H.J.; Kim S.B.; Lee C.S.
- Date Issued
- 2014-06
- Publisher
- IOP Publishing
- Abstract
- Dynamic tensile extrusion (DTE) tests with the strain rate order of similar to 10(5) s(-1) were conducted on coarse grained (CG) Cu and ultrafine grained (UFG) Cu. ECAP of 16 passes with route B-c was employed to fabricate UFG Cu. DTE tests were carried out by launching the sphere samples to the conical extrusion die at a speed of similar to 475 m/sec in a vacuumed gas gun system. UFG Cu was fragmented into 3 pieces and showed a DTE elongation of similar to 340%. CG Cu exhibited a larger DTE elongation of similar to 490% with fragmentation of 4 pieces. During DTE tests, dynamic recrystallization occurred in UFG Cu, but not in CG Cu. In order to examine the DTE behavior of CG Cu and UFG Cu under very high strain rates, a numerical analysis was undertaken by using a commercial finite element code (LS-DYNA 2D axis-symmetric model) with the Johnson - Cook model. The numerical analysis correctly predicted fragmentation and DTE elongation of CG Cu. But, the experimental DTE elongation of UFG Cu was much smaller than that predicted by the numerical analysis. This difference is discussed in terms of microstructural evolution of UFG Cu during DTE tests.
- URI
- https://oasis.postech.ac.kr/handle/2014.oak/37333
- DOI
- 10.1088/1757-899X/63/1/012144
- ISSN
- 1757-8981
- Article Type
- Article
- Citation
- IOP Conference Series : Materials Science and Engineering, vol. 63, no. 1, page. 12144, 2014-06
- Files in This Item:
-
Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.